The Jeep Cherokee starter sometimes fail with very little warning. I've had in the store parking lots, driveways and the first change in recent times my son's house. With this simple method you can use the Jeep running again soon and possibly avoid towing bill.
For most people, there is plenty of room to access the starter without jacking up the jeep. In fact, it makes it easier for jacking the past starting in the control group during the removalfrom the engine compartment.
Jump Starter
Remove the negative battery cable
Remove 8MM mother starter trigger wire to the magnet holds.
Remove the lower mounting screw. Note: This is a SAE bolt with 9 / 16, the head. They range from the front of the starter.
Remove the top bolt. It is 15 mm head, which runs from the transmission side metric.
Remove the starter enough to reduce and remove the battery cable from the terminal. This is a 13mm.
To install the newStarter, install the battery cable in place and move the trigger wire from the street.
Place the starter so that the indices in the hole of the base. Start the clamp bolt not more. This metric is the shortest.
Start the bottom bolt (SAE older) and ensure that the goodwill properly aligned with the hole in the base. Tighten the screws.
Connect the cable switch and tighten the nut.
Replace the battery.
After all thatis back in place, you can turn the key and start the Jeep. Be sure to reset the clock and radio presets that is lost to remove the battery.
How do you replace the starter on a Jeep Cherokee
No comments:
Post a Comment