Replace our car not starting car can be only one task, but we can not deny the fact that it is important to know how to replace a starter on their own.
The materials or tools needed to replace a starter, a sign, a flood light, a holding wrench, crescent wrench and a September
Jump Starter
to replace the first step is to prepare as a starter. We need an access from the floor, which means that the car on jack stands or the same car can be drawn, on averagejacked. We must assess the gypsum blocks, if they are in place and the brake when it all before lifting the vehicle to be set. An important tip is when under a car or other type of vehicle to be extremely careful, no electrical wires or other contacts who should not touch or be touched.
The second step is how to replace a starter, the starter, to be replaced. We have to find them, because there are different positions of appetizers and dependsthe model of the automotive industry. We begin to find the driver's side. Those who have not seen a starter before, most times, looks like a tube about six inches in diameter and eight inches in length. E 'with air holes of type on one end, which go all the way around the cylinder. It also has an assembly line and a few electrical connections. In the old car, the starter motor is on or within theEngine compartment.
Third step is to remove the links. As already mentioned, there are three compounds, ie, the connector assembly and the two electrical connections. These must be removed, but must be labeled to avoid confusion. When you remove the mounting port, are the tools to be used in the Crescent wrench and ratchet. It should be noted that there are times when the compounds are difficult to remove. The difficulty is very dependent on the age ofAutomobile. It also pointed out that not much use force must be the elimination of the compound, because it could further damage the machine and we could not go to the end.
The fourth step, how to replace a starter is installed. The reason it will highlight the connections in the third step, because the starter motor is installed with the reverse process of how the connections are removed.
The fifth step, how to replace a plant start-upthe negative battery cable to the battery. The connection must be tightened later. We can now verify that all connections are done by starting the engine.
We must not forget that the new starter a fee basis, so that the old starters are introduced into the shop to have the means to get a refund.
Know How to replace the starter of your car
No comments:
Post a Comment